quick release connector 10mm barbed fitting (3/8") coupling – black nickel

The male part of the High-End quick release connector.

The new generation of quick release connectors was specially designed for Highflow systems. It has the great quality of manufacturing that everyone is used to receive from Aquatuning. Both the male and female connector are equipped with a special profile to ensure that the pieces cannot cant, therefore ensuring that the connector is always sealed properly.
When connected the silicone ring of the male connector additionally expands to make contact with the female connector's inner wall to ensure the best seal possible.
To avoid any loosening when in use the two pieces are additionally connected by twisting them, making it impossible to separate them until they are twisted back.

The connector is equipped with a 10mm barbed fitting to ensure a maximum of compatibility.

Technical specifications:
Material: Nickel coated brass
Width: 18.4mm
Overall length: 47mm
Barbed fitting size: 10mm (3/8") for hoses with an inner diameter of 10mm

Extent of delivery:
1x Quick release connector 10mm (3/8") barbed fitting - black nickel - male

Important note regarding use of the connectors:
To ensure a tight seal between coupling and plug the units are designed for a very tight fit. When repeatedly plugging the connectors in and out, this may lead to roughening of the O-ring or even tearing of the gasket. Hence the gaskets should always be kept moist when plugging the connection in or out! A torn gasket is not covered by the warranty but is rather caused by incorrect use of the unit. Spare O-rings can be ordered with the item number 95002.

Note: For operation of the coupling the female counterpart is required

Info: Not entirely leak-proof, meaning that 1-2 drops may spill after separation)

Multiple quick release connectors reviewed at Aquainfos

Overview:
10mm (3/8") barbs: up to 8mm hose size no hose clamp required, from 10mm up required
10mm (7/16") barbs: up to 8mm hose size no hose clamp required, from 10mm up required
12mm (1/2") barbs: up to 11mm hose size no hose clamp required, from 12mm up required
13mm (1/2") barbs: up to 11mm hose size no hose clamp required, from 13mm up required