- Artikelnr.:: 63271
- EAN: 4049469088279
- Gewicht:: 0,047 kg
> 50 op voorraad
Prijzen incl. btw excl. verzendkosten
|1e pagina:||Slangtule 12 & 13mm (1/2")|
|2e pagina:||G1/4" Außengewinde|
|Compatibiliteit:||Stiff tubing (PUR), weiche Schläuche (PVC, Silikon, Neoprene)|
|Draaibaar:||Ja - 360°|
A well-known problem and here is the solution!
What is the best hose management to prevent kinking, how to avoid angled connectors to allow maximum flow? Now a well-known technology has been adopted to the watercooling sector by our designers to allow a solution which before was only possible with multiple different fittings.
The ball core of the fitting allows free adjustment of the barb, up to an angle of 30°. Even if using the full possibilities of this fitting the flow rate is barely compromised. The knurling on this fitting allows easy and quick tool-free installation.
This fitting gives many new possibilities unknown before!
Material: Black nickel coated
Height (without thread): 38mm
Diameter bottom end: 20mm
Hose fitting length: 24mm
Fitting inner diameter: 11mm
Thread length: 5mm
Compatible with hoses with an inner diameter of 13mm
Extent of delivery:
1x 13mm (1/2") barbed fitting G1/4 with O-ring gasket (high-flow) - ball rotation - black nickel
Note for watercooling beginners:
The connectors for hoses(7/16", 3/8",1/2") are provided with measurements in mm in our shop. These can differ by +-1mm, which is no problem as hose clamps have to be used for installation. If the hose is to be mounted without a clamp, a larger fitting should be chosen. With some fittings that tend to be larger, it is possible though that a hose with an inner diameter of 13mm actually does seal without a hose clamp.
10mm (3/8") hose clamp: up to 8mm none, from 10mm up required
10mm (7/16") hose clamp: up to 8mm none, from 10mm up required
12mm (1/2") hose clamp: up to 11mm none, from 12mm up required
13mm (1/2") hose clamp: up to 11mm none, from 13mm up required