|
12mm barb fitting nickel coated brass with O-ring seal for PVC, PU, PA, silicone or PE hoses with an inner diameter of 11-13mm. G1/4"" outer thread. The hose has to be fixated with a hose clamp or a zip tie. Inner diameter of fitting: 9,5mm. Note for watercooling beginners:The connectors for imperial hoses(7/16", 3/8", ½") are provided with measurements in mm in our shop. These can differ by +-1mm, which is no problem as hose clamps have to be used for installation. If the hose is to be mounted without a clamp, a larger fitting should be chosen. With some fittings that tend to be larger, it is possible though that a hose with an inner diameter of 13mm actually does seal without a hose clamp. Overview: 10mm (3/8") hose clamp: up to 8mm none, from 10mm up required 10mm (7/16") hose clamp: up to 8mm none, from 10mm up required 12mm (1/2") hose clamp: up to 11mm none, from 12mm up required 13mm (1/2") hose clamp: up to 11mm none, from 13mm up required This product will be shipped, unless otherwise specified, without a printed manual. For questions regarding the installation of the product, please contact our support. |
|
